Modules for Voltage Modular

Poly To Gate

An easy, purple way to send gate signals from a poly source or sequencer. 


This module generates up to 12 separate gate signals from a Poly input. The gates are controlled by 12 consecutive notes (or voltages at 1V/octave) starting with C in the chosen octave.

You can choose whether the output signal follows the Note On and Note Off signals or whether it just toggles with every Note On signal. You can also choose whether more than one output can be active at the same time.

If you are sitting there wanting a module that generates triggers instead of gates then you are in luck. Check out the sister module, Poly To Trigger.


Pitch and Gate In

A standard Poly input pair.


12x Gate Outputs

Activated by specific Note On and Note Off signals. Each socket has an LED that is lit when the gate signal is high.



Selects the octave that will be monitored.


Set this to Gate to have an output gate turn on with a Note On signal and turn off with a Note Off signal. This is probably the most common requirement.

Set it to Toggle to have an output toggle with every Note On signal.


Set this to Mono to allow only one gate to be active at any one time, determined by the most recent Note On signal.

Set it to Poly to allow more than one output to be active at once.